Kia Rio: Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
| •
|
Use care to keep foreign material out of the valve.
|
|
|
1. |
Installation is reverse of removal.
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the variable intake solenoid valve connector ( ...
See also:
Circuit Diagram
(M/T)
(A/T)
...
Installation
1.
Installation is the reverse of removal.
If the oil seal on the transaxle case side is da ...
Rear combination lamp Removal
Rear combination lamp (Inside)
[4 Door]
1.
Disconnect the negative (-) battery terminal.
2.
Remove the trunk trim.
(Ref ...
Removal
