Kia Rio: Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
| •
|
Insert the sensor in the installation hole and be careful
not to damage.
|
|
|
1. |
Installation is reverse of removal.
Manifold absolute pressure sensor
installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the manifold absolute pressure sensor connecto ...
See also:
Rear Hub - Carrier Inspection
1.
Check the hub for cracks and the splines for wear.
2.
Check the brake disc for scoring and damage.
3.
C ...
EBD(Electronic Brake-force Distribution) Operation
The Electronic Brake force Distribution (EBD) system as a sub-system of
the ABS system is to control the maximum braking effectiveness by the rear wheels.
It further utilizes the efficiency ...
Auto Defogging Sensor (FATC only) Description
The Auto Defogging Sensor is installed on the front windshild glass. The
Auto Defogging Sensor senses moisture on the windshild. The air conditioner
control module receives the signal from th ...
Removal
