Kia Rio: Measurement Method| Projected Dimensions |
| 1. |
These are the dimensions measured when the measurement points
are projected into the reference plane, and are the reference dimensions
used for body alterations.
|
| 2. |
If the length of the tracking gauge probes is adjustable, make
the measurement by lengthening one probe by the amount equivalent to
the difference in height of the two surfaces.
|
| Actual-Measurement Dimensions |
| 1. |
These dimensions indicate the actual linear distance between measurement
points, and are the reference dimensions for use if a tracking gauge
is used for measurement.
|
| 2. |
Measure by first adjusting both probes to the same length (A=A').
|
| Measurement Point |
| 1. |
Measurements should be taken at the hole center.
|
General
4Door Front Body AMaintenance under severe usage conditions
The following items must be serviced more frequently on cars normally used under
severe driving conditions.
Refer to the chart below for the appropriate maintenance intervals.
R : Replace
I : I ...
Description of ESC
Electronic Stability Control (ESC) recognizes critical driving conditions,
such as panic reactions in dangerous situations, and stabilizes the vehicle
by wheel-individual braking and engine c ...
5Door Rear Body
Side outer panel rear corner
Tail gate hinge mounting hole (Ø14)
Tail gate hinge mounting hole (Ø1 ...