Kia Rio: Special Service Tools

Tool (Number and name)	Illustration	Use
Crankshaft front oil seal installer (09455-21200)		Installation of the front oil seal
Valve stem oil seal installer (09222-2B100)		Installation of the valve stem oil seal
Valve spring compressor and holder A : (09222-3K000) B : (09222-3K100)		Removal and installation of the intake or exhaust valve
Crankshaft rear oil seal installer A : (09231-H1100) B : (09231-2B200)		Installation of the crankshaft rear oil seal
Ring gear stoppper (09231-2B100)		Installation of crankshaft pulley bolt
Engine coolant temperature sensor socket wrench (09221-25100)		Removal and installation of engine coolant sensor
Oil pan remover (09215-3C000)		Removal of oil pan
Torque angle adapter (09221-4A000)		Installation of bolts & nuts needing an angular method

Troubleshooting

Symptom Suspect area Remedy Engine misfire with abnormal internal lower engine noises. Loose or improperly installed engine flywheel. Repair or replace ...

Engine And Transaxle Assembly

...

See also:

Heater & A/C Control Unit (MANUAL) Components
Connector pin function Connector Pin No Function Connector Pin No Function A 1 Ground B 18 Intake Actu ...

Dynamic Damper Components
1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 1 ...

Mode Control Actuator Description
The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch ...

Categories

Copyright © www.kirmanual.com 2014-2026