Kia Rio: Measurement Point

Measurements should be taken at the center of the hole.

Measuring Actual Dimensions

1. These dimensions indicate the actual linear distance between measurement points, and are used as the reference dimensions when a tracking gauge is used for measurem ...

Checking Cables And Wires

1. Check the terminal for tightness. 2. Check terminals and wires for corrosion from battery electrolyte, etc. 3. ...

See also:

Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ...

AGM Battery: Specification
Item Specification Model type AGM 70L-DIN Capacity [20HR/5HR] (AH) 70/56 Cold Cranking Amperage (A) 760 (SAE) / 610 (EN) ...

Radiator: Removal and Installation
1. Disconnect the battery negative terminal. Tightening torque (-) terminal (without battery sensor): 7.8 ~ 9.8N.m (0.8 ~ 1.0 ...