Kia Rio: Torque Converter Control Solenoid Valve (T/CON_VFS) Inspection - Automatic Transaxle Control System - Automatic Transaxle System - Kia Rio UB 2012-2026 Service ManualKia Rio: Torque Converter Control Solenoid Valve (T/CON_VFS) Inspection

1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resistance is within the specification.
Torque Converter Control Solenoid Valve (T/CON_VFS) Circuit Diagram
...

Torque Converter Control Solenoid Valve (T/CON_VFS) Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

See also:

Alternator: Specification
Items Specification  ISG Alternator Rated voltage 13.5V, 110A Speed in use 1,000 ~ 18,000rpm Voltage regulator ...

Ending voice recognition
While Voice Recognition is operating Press and hold the key on the steering remote controller (over 0.8 seconds) While using voice command, pressing any steering wheel control or a differen ...

Trunk
Opening the trunk With the trunk lid release lever To open the trunk from inside the vehicle, pull up the trunk lid release lever. The trunk will automatically lock when the trunk lid closes. & ...

Copyright www.kirmanual.com 2014-2026