Kia Rio: Power Door Lock Switch Removal - Power Door Locks - Body Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Power Door Lock Switch Removal

1.
Disconnect the negative(-) battery terminal.
2.
Remove the front door trim panel.
(Refer to the BD group - "Front door")
3.
Disconnect the power window switch module connector (A) from the wiring harness.


4.
Remove the power window switch module (A) from the door trim after loosening the mounting screws (5EA).



     
-
Be careful not to damage door trim panel and door module mounting hooks.
Power Door Lock Switch Inspection
Driver Door Lock Switch Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim panel. (Refer to t ...

Power Door Lock Switch Installation
1. Install the power window switch module. 2. Install the door trim panel after reconnecting the relevant connectors ...

See also:

Heater Unit Components
1. Shower Duct (Left) 2. Heater Pipe Cover 3. Mode Control Actuator 4. Mode Control Actuator Bracket 5. Defog mode lever (FATC) 6. Mode Control Main Lever (MANUAL) 7. Vent ...

General
1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is ...

Hazard warning flasher   lighting
The hazard warning flasher should be used whenever you find it necessary to stop the car in a hazardous location. When you must make such an emergency stop, always pull off the road as far as po ...

Copyright www.kirmanual.com 2014-2026