Kia Rio: Power Door Lock Switch Installation - Power Door Locks - Body Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Power Door Lock Switch Installation

1.
Install the power window switch module.
2.
Install the door trim panel after reconnecting the relevant connectors

     
-
Make sure that the power window switch module connectors are plugged properly.
-
Check that the power window switch and door lock switch operate normally.
Power Door Lock Switch Removal
1. Disconnect the negative(-) battery terminal. 2. Remove the front door trim panel. (Refer to the BD group - "Front door") ...

Power Door Mirrors
...

See also:

Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The top waveform is from the high side (feed side) of the #1 and #4 injectors, while the middle waveform is from the low side ...

Roll Over Valve (ROV): Repair procedures
Removal 1. Remove the fuel pump. (Refer to Engine Control/Fuel System - “Fuel Pump”) 2. Remove the roll over valve (A) after relea ...

Specification
Item Specification Coil Resistance (Ω) 0.5 [20°C(68°F) ...

Copyright www.kirmanual.com 2014-2026