Kia Rio Manuals

Kia Rio: Power Mosfet (FATC) Inspection - Blower - Heating,Ventilation, Air Conditioning - Kia Rio UB 2012-2026 Service ManualKia Rio: Power Mosfet (FATC) Inspection

1.
Turn the ignition switch ON.
2.
Manually operate the control switch and measure the voltage of blower motor.
3.
Select the control switch to raise voltage until high speed.


Specification
Fan Speed
(Manual)
 Motor Voltage (V)
1
 3.75 ± 0.5
2
 4.76 ± 0.5
3
 6.87 ± 0.5
4
 6.99 ± 0.5
5
 8.11 ± 0.5
6
 9.23 ± 0.5
7
 10.63 ± 0.5
8
 Battery

4.
If the measured voltage is not within specification, substitute with a known-good power mosfet and check for proper operation.
5.
Replace the power mosfet if it is proved that there is a problem with it.
Blower Resistor (MANUAL) Replacement
1. Disconnect the negative (-) battery terminal. 2. Disconnect the connector (A) and then remove the blower resistor (B) after loosening th ...

Power Mosfet (FATC) Replacement
1. Disconnect the negative (-) battery terminal. 2. Disconnect the connector (A) and then remove the power mosfet (B) after loosening the m ...

See also:

Troubleshooting
Problem Symptoms Table Use the table below to help you find the cause of theproblem. The numbers indicate the priority of the likecause of the problem. Check each part in order. ...

Rear Wheel Speed Sensor Components
1. Rear wheel speed sensor connector 2. Rear wheel speed sensor ...

Weight Classification System (WCS) Installation
   WCS(Weight Classification System) is utilizing a robust weight measuring technology. Thus, if any of the following condi ...

Categories

Copyright www.kirmanual.com 2014-2026