Kia Rio Manuals

Kia Rio: Rain Sensor Installation - Windshield Wiper/Washer - Body Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Rain Sensor Installation


     
•
In case of the windshield with reflection layer which reflects the infrared rays in sensing field, remove the reflection layer from the rain sensor mounting position prior to installation.
•
Avoid contamination of the sensor during installation.
1.
Install the rain sensor bracket to the windshield glass using the tape.



     
It is very important that the coupling pad pushes against the windshield completely to prevent bubbles from forming at the contact surface.
2.
Connect the rain sensor connector, and then install the sensor cover.
Rain Sensor Removal
   The rain sensor may not operate properly if contaminated. Protect the rain sensor surface by not removing the cover unti ...

Rear Wiper/Washer
...

See also:

ESC Control Module Removal
1. Turn ignition switch OFF. 2. Pull up the lock of the HECU connector (A), and then disconnect the connector. ...

Blower Resistor (MANUAL) Inspection
1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replac ...

Rear Door Components
1 . Rear door trim 2 . Rear door trim seal 3 . Rear door panel 4 . Rear door belt inside weatherstrip 5 . Rear door belt outside weatherstrip 6 . Rear door delta lower ...

Categories

Copyright www.kirmanual.com 2014-2026