Kia Rio: Rain Sensor Removal
The rain sensor may not operate properly if contaminated. Protect
the rain sensor surface by not removing the cover until installation
time. The coupling pad on the rain sensor surface has adhesive strength.
Take care when installing the sensor. If the sensor is separated from
the windshield by force, the sensor or windshield may be damaged. Take
care when removing the sensor.
|
| 1. |
Remove the rain sensor cover (A) first.
Be careful not to damage the cover latch by applying excessive
force. To remove the latch, pull aside the latch using the cover hole
(B) with the little (-) screwdriver (C).
|
| 2. |
Remove the wiring harness connector (D) from sensor.
|
| 3. |
Rain sensor module is attached to the front windshield by glue
replacing the front windshield, remove the rain sensor module from the
existing front windshield and install on the new front windshield.
|
Rain Sensor Inspection
Rain Sensing Wiper
1.
In IGN2 ON state, if auto switch input (LIN communication) is
ON then both wiper low relay and wiper high relay outputs are controlled
by the ...
Rain Sensor Installation
•
In case of the windshield with reflection layer which
reflects the infrared rays in ...
See also:
Measuring Body Dimensions
1.
Basically, all measurements in this manual are taken with a tracking
gauge.
2.
When a measuring tape is used, check to be sure there is ...
Special Service Tools
Tool (Number and name)
Illustration
Use
Alternator pulley remover wrench
(09373-27000)
Removal and installation of alternator pulley
...
Removal
1.
Remove the under cover.
2.
Remove the mounting nut and disconnect the horn connector, then
remove the horn (A).
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026