Kia Rio: Rear combination lamp Installation| Rear combination lamp (Inside) |
| 1. |
Install the rear combination lamp assembly.
|
| 2. |
Connect the rear combination connector.
|
| 3. |
Install the trunk trim.
|
| 4. |
Connect the negative (-) battery terminal.
|
| 1. |
Install the rear combination lamp assembly.
|
| 2. |
Connect the rear combination connector.
|
| 3. |
Connect the negative (-) battery terminal.
|
| Rear combination lamp (Outside) |
| 1. |
Install the rear combination lamp assembly.
|
| 2. |
Connect the rear combination lamp connector.
|
| 3. |
Connect the negative (-) battery terminal.
|
Rear combination lamp Removal
TroubleshootingCruise Control
The cruise control system is engaged by the cruise "ON/OFF" main switch
located on right of steering wheel column. The system has the capability to
cruise, coast, accelerate and res ...
Specification
[Throttle Position Sensor (TPS)]
Throttle angle(°)
Output Voltage (V)
TPS1
TPS2
0
0.5
4.5
10
0.96
4.05
...
Waveform
This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft
Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition
timing by using these sig ...