Kia Rio: Rear Wiper Motor Inspection
Rear Wiper Motor
| 1. |
Remove the 4P connector from the rear wiper motor.
|
| 2. |
Connect battery positive (+) and negative (-) cables to terminals
4 and 1 respectively.
|
| 3. |
Check that the motor operates normally. Replace the motor if it
operates abnormally.
|
Automatic Stop Operation Check
| 1. |
Operate the motor at low speed using the stalk control.
|
| 2. |
Stop the motor operation anywhere except at the off position by
disconnecting terminal 3.
|
| 3. |
Connect terminals 2 and 3.
|
| 4. |
Connect the positive (+) lead from the battery to terminal 1 and
the negative (-) lead to terminal 4.
|
| 5. |
Check that the motor stops running at the off position.
|
Rear Wiper Motor Installation
1.
Install the rubber packing.
2.
Install the rear wiper motor assembly.
Tightening torque :
6.86 ~ 9.81N ...
Rear Washer Switch Inspection
1.
With the rear wiper & washer switch in each position, make sure
that continuity exists between the terminals below. If continuity is
not as specified, replace t ...
See also:
Operation Condition for the ISG function
1. Auto stop or Auto start condition
(If all of the below condition are satisfied)
Items
State
Remark
Driving conditions
ISG OFF Switch
...
Rear Shock Absorber Inspection
1.
Check the components for damage or deformation.
2.
Compress and extend the piston and check that there is no abnormal
resistance or unus ...
Steering Angle Sensor (MDPS Only) Description
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power
Steering) and it sends messages to HECU through CAN communication line.
The SAS is used to determine turning directio ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026