Kia Rio: Rear Washer Switch Inspection - Rear Wiper/Washer - Body Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Rear Washer Switch Inspection

1.
With the rear wiper & washer switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunction switch.


Rear Wiper Switch


Rear Washer Switch


Rear Wiper Motor Inspection
Rear Wiper Motor 1. Remove the 4P connector from the rear wiper motor. 2. Connect battery positive (+) and negative (-) cables to terminals ...

Rear Washer Motor Inspection
1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. 2. Remove the front bumper cover. (Refer to t ...

See also:

Removal
1. Disconnect the battery negative terminal. 2. Disconnect the air compressor connector (A) and the alternator connector (B), and remove th ...

Power Door Lock Actuators Inspection
Front Door Lock Actuator and Switch 1. Remove the front door trim. (Refer to the Body group - Front door) 2. Remove the front door l ...

Removal
1. Remove the front wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~79.6 lb-ft) ...

Copyright © www.kirmanual.com 2014-2026