1. |
Detach the wiper cap (A) and remove a nut (B).
|
2. |
Remove the rear wiper arm & blade (A).
|
3. |
Remove the rubber packing (A).
|
4. |
Open the tailgate then remove the tailgate trim.
(Refer to the BD group - "Tail gate")
|
5. |
Disconnect the rear wiper motor connector (A) then remove the
rear wiper motor (B) after removing 3 bolts.
|
Rain Sensor Inspection
Rain Sensing Wiper
1.
In IGN2 ON state, if auto switch input (LIN communication) is
ON then both wiper low relay and wiper high relay outputs are controlled
by the ...
Component Location (3)
[5 Door]
1. Back up lamp
2. Turn signal lamp
3. Tail lamp/ Stop lamp
4. Tail lamp
5. Stop lamp
6. Side marker lamp
7. High mounted stop lamp
8. Lic ...
Special Service Tools
Tool (Number and name)
Illustration
Use
09411-1P000
Clutch disc guide
Installation of the clutch disc.
...