1. |
Disconnect the negative (-) battery terminal.
|
2. |
Push hooks in the engine room relay box out to the arrow direction
and put up the EMS box assembly (A).
|
3. |
Disconnect the connector (A) and remove the EMS box assembly (B).
|
1. |
Be sure there is no play in the fuse holders, and that the fuses
are held securely.
|
2. |
Are the fuse capacities for each circuit correct?
|
3. |
Are there any blown fuses?
If a fuse is to be replaced, be sure to use a new fuse of the
same capacity. Always determine why the fuse blew first and completely
eliminate the problem before installing a new fuse.
|
|
Overhead Console Lamp Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the overhead console lamp lens (B).
3.
After ...
Alternator: Removal and installation
1.
Disconnect the battery negative terminal first, then the positive
terminal.
Tightening torque
(+) terminal :
7 ...
Fuel Pump Installation
1.
Installation is reverse of removal.
Fuel pump plate cover installation
bolt :
1.96 ~ 2.94 N.m (0.2 ~ 0.3 kgf.m, 1.44 ~ 2.17 lb- ...