Kia Rio: Removal
| 1. |
Disconnect the battery terminal (A).
|
| 2. |
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
| 3. |
Remove the battery mounting bracket and the insulation pad (A),
and then remove the battery(B).
|
| 4. |
Disconnect the ECM connector (A), and then remove ECM (B) after
removing the bolts/nut.
|
| 5. |
Remove the battery tray (C) after removing the bolts.
|
Adjustment
Battery charging
In general, vehicle battery charging system has three forms.
1.
Constant current charge: The battery voltage gradually rises by
chargi ...
Installation
1.
Install in the reverse order of removal.
Battery (-)terminal installation
[with battery sensor] :
4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf. ...
See also:
Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The
top waveform is from the high side (feed side) of the #1 and #4 injectors, while
the middle waveform is from the low side ...
Smart key unit Inspection
Smart Key Unit
-
Refer to the BE group - inspection / self diagnosis with GDS.
Smart Key Switch
-
Refer to the BE group - inspection / self di ...
Installation
When replacing the ECM, the vehicle equipped with immobilizer
must be performed the procedure as below.
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026