Kia Rio: Removal - Brake Line - Brake System - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal

1.
Disconnect the brake fluid level switch connector, and remove the reservoir cap.
2.
Remove the brake fluid from the master cylinder reservoir with a syringe.

     
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
3.
Remove the wheel & tire.
4.
Loosening the tube flare nut (B).

Tightening torque:
12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)

[Front]


[Rear]


5.
Disconnect the brake tube by remove the brake hose clip (A).
6.
Disconnect the brake hose from the brake caliper by loosening the bolt (A).

Tightening torque:
24.5 ~ 29.4 N.m (2.5 ~ 3.0 kgf.m, 18.1 ~ 21.7 lb-ft)

[Front disc brake]


[Rear Disc brake]


Components
...

Inspection
1. Check the brake tubes for cracks, crimps and corrosion. 2. Check the brake hoses for cracks, damage and fluid leakage. 3 ...

See also:

Head lamp leveling Actuator Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the head lamp assembly (Refer to the head lamp). 3. ...

Foot Actuator (With Auto Defogging System) Description
The foot actuator is located at the heater unit. It adjusts position of the foot door in heater unit of the vehicle equipped with the auto defogging system. ...

Brake Booster Vacuum Pressure Sensor: Circuit Diagram
...

Copyright www.kirmanual.com 2014-2026