Kia Rio Manuals

Kia Rio: Removal - Camshaft Position Sensor (CMPS) - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal


     
•
DON’T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.
[Bank 1 / Intake]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the camshaft position sensor connector (A).
3.
Remove the installation bolt (B), and then remove the sensor.
[Bank 1 / Exhaust]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the camshaft position sensor connector (A).
3.
Remove the hanger and the protector.
4.
Remove the installation bolt (B), and then remove the sensor.
Inspection
1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” ...

Installation
   • Install the component with the specified torques. • ...

See also:

ESC Control Module Components
1. Front - left tube 2. Rear - right tube 3. Rear - left tube 4. Front - right tube 5. MC2 6. MC1 7. ESC control module (HECU) 8. Damper 9. Bracket ...

Circuit Diagram
(M/T) (A/T) ...

Water pump: Inspection
1. Check each part for cracks, damage or wear, and replace the coolant pump assembly if necessary. 2. Check the bearing for damage, abnorma ...

Categories

Copyright www.kirmanual.com 2014-2026