Kia Rio Manuals

Kia Rio: Replacement - Rear Disc Brake - Brake System - Kia Rio UB 2012-2026 Service ManualKia Rio: Replacement

Rear Brake Pads
1.
Loosen the guide rod bolt (B) and then remove the rear caliper body (A).
Tightening torque:
21.6 ~ 31.4 N.m (2.2 ~ 3.2 kgf.m, 15.9 ~23.1 lb-ft)



     
•
Where necessary prevent the guide rods from rotating with an appropriate wrench.
•
Be careful not to damage the dust covers.
2.
Replace pad retainers (A) and brake pads (B) in the caliper carrier (C).



     
•
Clean the pad retainer surface at the caliper bracket.
•
Inspect the piston boots for damage and replace if necessary.
•
Check the smooth action of the guide rods, and their dust covers for damage.
Removal
1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Inspection
Rear Brake Disc Thickness Check 1. Check the brake pads for wear and fade. 2. Check the brake disc for damage and cracks. ...

See also:

Instrument Cluster Installation
1. Connect the cluster connector. 2. Install the cluster assembly. 3. Install the center fascia panel. ...

Rear Door Components
1 . Rear door trim 2 . Rear door trim seal 3 . Rear door panel 4 . Rear door belt inside weatherstrip 5 . Rear door belt outside weatherstrip 6 . Rear door delta lower ...

Multimedia Jack Installation
1. Install the multimedia jack. 2. Connect the multimedia jack connector.    ...

Categories

Copyright www.kirmanual.com 2014-2026