Kia Rio Manuals

Kia Rio: Removal - Rear Disc Brake - Brake System - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal

1.
Remove the rear wheel & tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
2.
Remove the parking brake cable (A), after removing the clip (B).



     
Parking brake lever in the car must be in fully loosened position.
3.
Remove the hose eyebolt (B).
Tightening torque:
Brake hose to caliper:
24.5 ~ 29.4 N.m (2.5 ~ 3.0 kgf.m, 18.1 ~ 21.7 lb-ft)


4.
Loosen the caliper mounting bolts (C), then remove the rear caliper assembly (A).
Tightening torque:
Caliper assembly to carrier:
49.0 ~ 58.8 N.m (5.0 ~ 6.0 kgf.m, 36.2 ~ 43.4 lb-ft)


5.
Remove the rear brake disc by loosening the screws (A).
Components
1. Guide rod bolt 2. Bleed screw 3. Caliper carrier 4. Caliper body 5. Brake pad 6. Pad retainer ...

Replacement
Rear Brake Pads 1. Loosen the guide rod bolt (B) and then remove the rear caliper body (A). Tightening torque: 21.6 ~ 31 ...

See also:

Brake Switch Inspection
1. Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in an ...

Inspection
Connecting Rod And Crankshaft 1. Check the connecting rod end play. Using feeler gauge, measure the end play while moving the connecting rod back and f ...

Circuit Diagram
(M/T) (A/T) ...

Categories

Copyright www.kirmanual.com 2014-2026