Kia Rio: Transmitter Code Registration (Using GDS)
| 1. |
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
|
| 2. |
Select the vehicle model and then do "CODE SAVING"
|
| 3. |
After selecting "CODE SAVING" menu, button "ENTER" key, then the
screen will be shown as below.
|
| 4. |
After removing the ignition key from key cylinder, push "ENTER"
key to proceed to the next mode for code saving. Follow steps 1 to 4
and then code saving is completed.
|
Transmitter Inspection
1.
Check that the red light flickers when the door lock or unlock
button is pressed on the transmitter.
2.
Remove the battery and check vol ...
See also:
Back-up Lamp Switch Replacement
1.
Disconnect the back up lamp switch connector (A).
2.
Remove the back up lamp switch (A).
3.
...
Spark Plug: Removal
1.
Remove the ignition coil.
(Refer to Ignition System - "Ignition Coil")
2.
Using a spark plug wrench, remove the spark plu ...
Relay Box (Passenger Compartment) Removal
Passenger Compartment Junction Box
1.
Disconnect the negative(-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to th ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026