Kia Rio: Windshield Wiper-Washer Switch Removal - Windshield Wiper/Washer - Body Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Windshield Wiper-Washer Switch Removal

Wiper and Washer Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
3.
Remove the steering column upper (A) and lower (B) shrouds after removing the screw.



4.
Disconnect the connector(A). Release the lock of wiper switch using tool without removing the steering wheel and the clock spring.
Remove the wiper and washer switch.


Windshield Wiper-Washer Switch Inspection
Wiper And Washer Switch Inspection With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace ...

Windshield Wiper-Washer Switch Installation
1. Install the wiper switch. 2. Install the steering column upper and lower shrouds. ...

See also:

Fuel Pressure Test (Low pressure system)
1. Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line"). ...

Meaning Of Symbols
There are five primary symbols used to complement illustrations. These symbols indicate the part to apply such materials during service. Symbol Meaning ...

Vehicle parasitic current inspection
1. Turn the all electric devices OFF, and then turn the ignition switch OFF. 2. Close all doors except the engine hood, and then lock all d ...

Copyright www.kirmanual.com 2014-2026