Kia Rio: Thermostat: Troubleshooting - Cooling System - Engine Mechanical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Thermostat: Troubleshooting

Symptoms
Possible Causes
Remedy
Coolant leakage
•
From the thermostat gasket
Check the mounting bolts
•
Check the torque of the mounting bolts
•
Retighten the bolts and check leakage again.
Check the gasket for damage
•
Check gasket or seal for damage
•
Replace gaskets and reuse the thermostat.
Cooled excessively
•
Low heater performance (cool air blowed-out)
•
Thermogauge indicates 'LOW'
Visually check after removing the radiator cap.
•
Insufficient coolant or leakage.
•
After refilling coolant, recheck.
GDS check&Starting engine
•
Check DTCs
•
Check connection of the fan clutch or the fan motor.
※ If the fan clutch is always connected, there will be a noise at idle.
•
Check the engine coolant sensor, wiring and connectors.
•
Replace the componants.
Remove the thermostat and inspect
•
Check if there are dusts or chips in the thermostat valve.
•
Check adherence of the thermostat.
•
Clean the thermostat valve and reuse the thermostat.
•
Replace the thermostat, if it doesn't work properly.
Heated excessively
•
Engine overheated
•
Thermogauge indicates 'HI'
Visually check after removing the radiator cap.
•
Insufficient coolant or leakage.
※ Be careful when removing a radiator cap of the overheated vehicle.
•
Check air in cooling system.
•
After refilling coolant, recheck.
•
Check the cylinder head gaskets for damage and the tightening torque of the mounting bolts.
GDS check&Starting engine
•
Check DTCs
•
Check the fan motor performance as temperature varies.
•
Check if the fan clutch slips.
•
Check the water pump adherence or impeller damaged.
•
Check the engine coolant sensor, wiring and connectors.
•
Check the fan motor, the relay and the connector.
•
Replace the fan clutch, if it doesn't work properly.
•
Replace the water pump, if it doesn't work properly.
Immerse the thermostat in boiling water and inspection.
•
After removing the thermostat, check it works properly.
※ Check the thermostat opens at the valve opening temperature.
•
Replace the thermostat, if it doesn't work properly.

Thermostat: Installation
1. Place the thermostat in the block. Install the thermostat (B) with the jiggle valve upward. 2. Install the water inlet fitting (A). ...

Water pump: Removal and Installation
Water Pump 1. Drain engine coolant.    System is under high pre ...

See also:

Front Seat Belt Replacement
Front Seat Belt Replacement    • When installing the belt, make sure not to damaged the ...

SS-A Solenoid Valve(ON/OFF) Installation
1. Installation is the reverse of removal.    • When installing ...

Component Location
1. Auto light sensor 2. Head lamps 3. Lighting switch (Auto) 4. Tail lamps 5. BCM (Body Control Module) ...

Copyright © www.kirmanual.com 2014-2026