Kia Rio: Rear Wiper Motor Removal
| 1. |
Detach the wiper cap (A) and remove a nut (B).
|
| 2. |
Remove the rear wiper arm & blade (A).
|
| 3. |
Remove the rubber packing (A).
|
| 4. |
Open the tailgate then remove the tailgate trim.
(Refer to the BD group - "Tail gate")
|
| 5. |
Disconnect the rear wiper motor connector (A) then remove the
rear wiper motor (B) after removing 3 bolts.
|
Component Location
1. Head cap
2. Nut
3. Rear wiper arm & Blade
4. Packing (rubber)
5. Rear wiper motor assembly
6. Bolt
...
Rear Wiper Motor Installation
1.
Install the rubber packing.
2.
Install the rear wiper motor assembly.
Tightening torque :
6.86 ~ 9.81N ...
See also:
ECM Terminal And Input/Output signal [A/T]
ECM Terminal Function (A/T)
Connector [EGGA-AG]
Pin No.
Description
Connected to
1
Injector (Cylinder #1) [High] control output
...
Temperature Control Actuator Description
The heater unit includes mode control actuator and temperature control
actuator.
The temperature control actuator is located at the heater unit. It regulates
the temperature by the proced ...
Smart Key
Smart Key Code Saving
1.
Connect the DLC cable of GDS to the data link connector in driver
side crash pad lower panel, turn the power on GDS.
2.
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2025 Owners Manual
- Kia Rio YB 2017-2025 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2025