Kia Rio: Circuit Diagram

Signal Waveform

...

Inspection

1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S termi ...

See also:

Heater & A/C Control Unit (MANUAL) Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the heater & A/C controller (A) from the center facia using a flat-head scre ...

Front Wiper Motor Inspection
Speed Operation Check 1. Remove the connector (A) from the wiper motor. 1. - 2. IGN+ 3. Parking 4. High 5. GND 6. Low ...

Component(1)
※ Installation order : A → B → C → D → E 1. Steering column shaft 2. Lighting switch 3. Wiper and washer switch 4. Screw 5. Steering angle ...