Kia Rio: Hazard Lamp Switch Installation - Lighting System - Body Electrical System - Kia Rio UB 2012-2024 Service ManualKia Rio: Hazard Lamp Switch Installation

1.
Connect the connectors.
2.
Install the hazard lamp switch.
3.
Connect the negative (-) battery terminal.
Hazard Lamp Switch Removal
1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or trim remover, remove the hazard lamp switch (A). ...

Hazard Lamp Switch Inspection
1. Operate the switch and check for continuity between terminals. ...

See also:

Removal
   • Frequent inhalation of brake pad dust, regardless of material composition, could be ha ...

Specifications
Item Requirement Remark Rated voltage DC 12V Shall activate normally in these range. Operating voltage range DC 9 ~ 16V ...

BCM connectors
Pin No. Connector A Connector B Connector C 1 Battery (+) K_LINE Turn signal switch (RH) 2 Ignition 2 Centr ...

Copyright © www.kirmanual.com 2014-2024