Kia Rio: Hazard Lamp Switch Removal - Lighting System - Body Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Hazard Lamp Switch Removal

1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or trim remover, remove the hazard lamp switch (A).



3.
Disconnect the hazard lamp switch connector.
License Lamp Installation
1. Install the bulb. 2. Connect the lens and license lamp. ...

Hazard Lamp Switch Installation
1. Connect the connectors. 2. Install the hazard lamp switch. 3. Connect the negative (-) battery terminal. ...

See also:

Specifications
Item Specifications Transmission type A6GF1 Engine model Gasoline 1.6 GDI Torque converter type 3-element, 1-stage, 2-phas ...

Waveform
This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using these sig ...

Description
TREAD Lamp - Tire Under Inflation / Leak Warning. 1. Turn on condition A. When tire pressure is below a ...

Copyright www.kirmanual.com 2014-2026