Kia Rio: Ignition Switch Assembly Installation

1.

Install the key lock cylinder.

When assembling, the key must be inserted at 'ACC' position.

2.	Install the key warning and immobilizer connector.

3.	Install the ignition switch.

4.	Install the steering column shrouds and crash pad lower panel.

Ignition Switch Assembly Removal

1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds. (Refer to the ST group - & ...

Back View Camera System

...

See also:

Troubleshooting
Problem Symptoms Table Use the table below to help you find the cause of theproblem. The numbers indicate the priority of the likecause of the problem. Check each part in order. ...

26 Brake Control Solenoid Valve(26/B_VFS) Specifications
Direct control VFS[26/B] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 9.81 ~ 500.14 (0.1 ~ 5.1, 1.42 ~ 72.54) Current value(mA ...

Circuit Diagram
(M/T) (A/T) ...

Categories

Copyright © www.kirmanual.com 2014-2026