Kia Rio: Photo Sensor (FATC only) Inspection
| 1. |
Turn the ignition switch ON.
|
| 2. |
Connect the GDS.
|
| 3. |
Emit intensive light toward photo sensor using a lamp, and check
the output voltage change.
|
| 4. |
The voltage will rise with higher intensive light and reduce with
lower intensive light.
|
Photo Sensor (FATC only) Description
The photo sensor is located at the center of defrost nozzles.
The photo sensor contains a photovoltaic (sensitive to sunlight) diode.
The solar radiation received by its light receiving port ...
Photo Sensor (FATC only) Replacement
1.
Disconnect the negative (-) battery terminal.
2.
With a flat-head screwdriver, remove the photo sensor (A) from
the center of defrost no ...
See also:
Component Location (3)
[5 Door]
1. Back up lamp
2. Turn signal lamp
3. Tail lamp/ Stop lamp
4. Tail lamp
5. Stop lamp
6. Side marker lamp
7. High mounted stop lamp
8. Lic ...
Installation
Rear Disc Brake Type
1.
Install the parking brake cable.
2.
Install the parking brake cable (A), and then install the clip
(B ...
Inspection
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the fuel pressure regulator valve connector.
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026