Kia Rio: Blower Resistor (MANUAL) Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Disconnect the connector (A) and then remove the blower resistor (B) after loosening the mounting screws.

3.	Install in the reverse order of removal.

Blower Resistor (MANUAL) Inspection

1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replac ...

Power Mosfet (FATC) Inspection

1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of blower motor. 3. ...

See also:

Warnings and indicators
All warning lights are checked by turning the ignition switch ON (do not start the engine). Any light that does not illuminate should be checked by an authorized Kia dealer. After starting the en ...

Alternator: Removal and installation
1. Disconnect the battery negative terminal first, then the positive terminal. Tightening torque (+) terminal : 7 ...

Special Service Tools
Tool (Number and name) Illustration Use Alternator pulley remover wrench (09373-27000) Removal and installation of alternator pulley ...

Categories

Copyright © www.kirmanual.com 2014-2026