Kia Rio: Electrical System
| 1. |
Be sure to disconnect the battery cable from the negative (-)
terminal of the battery.
|
| 2. |
Never pull on the wires when disconnecting connectors.
|
| 3. |
Locking connectors will click when the connector is secure.
|
| 4. |
Handle sensors and relays carefully. Be careful not to drop them
against other parts.
|
Preparation Of Tools And Measuring Equipment
Be sure that all necessary tools and measuring equipment are available
starting work.
Special Tools
Use special tools when they are required.
Removal Of Parts
First find the cause ...
Rubber Parts And Tubes
Always prevent gasoline or from touching rubber parts or tubing.
...
See also:
A/C Pressure Transducer Inspection
1.
Measure the pressure of high pressure line by measuring voltage
output between terminal “1” and “2”.
2.
Inspect the volt ...
Accelerator Pedal Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Disconnect the accelerator position sensor connector (A). ...
Heater & A/C Control Unit (FATC) Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater & A/C controller (A) from the center facia using
a flat-head scre ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026