Kia Rio: Rubber Parts And Tubes

Always prevent gasoline or from touching rubber parts or tubing.

Electrical System

1. Be sure to disconnect the battery cable from the negative (-) terminal of the battery. 2. Never pull on the wires when disconnecting con ...

Measuring Body Dimensions

1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is ...

See also:

Component Location (1)
1. Head lamp (Low/ High) 2. Head lamp (Low) 3. Head lamp (High) 4. Turn signal lamp 5. DRL/ Position lamp 6. Side marker lamp 7. Turn signal lamp (Door mirror) 8. F ...

Torque Converter Control Solenoid Valve (T/CON_VFS) Specifications
Direct control VFS[T/CON] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 9.81 ~ 500.14 (0.1 ~ 5.1,1.42 ~ 72.54) Current value(mA ...

Replacement
The injector combustion seal should be replaced new one to prevent leakage after removing the injector. 1. Remove the combustion seal (A) with a wire cutter. ...