Kia Rio: Fuel Filler Cap - Evaporative Emission Control System - Emission Control System - Kia Rio UB 2012-2026 Service ManualKia Rio: Fuel Filler Cap

Description

A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler. After the gasket on the fuel filler cap and the filler neck flange contact each other, the ratchet produces a loud clicking noise indicating the seal has been set.


1. Cover
2. Torsion spring
3. Retainer
4. Gasket seal
5. Spring
6. Plate seal
7. Vacuum valve
8. Spring

Roll Over Valve (ROV): Repair procedures
Removal 1. Remove the fuel pump. (Refer to Engine Control/Fuel System - “Fuel Pump”) 2. Remove the roll over valve (A) after relea ...

Fuel Tank Air Filter
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Lift the vehicle. 3. ...

See also:

Speakers Installation
Front Speaker 1. Install the front speaker. 2. Install the front door trim. Rear Speaker 1. Install the ...

Door Switch Installation
1. Install is reverse of removal. ...

Front Lower Arm Replacement
1. Remove the front wheel & tire. Tightening torque : 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Copyright www.kirmanual.com 2014-2026