Kia Rio: Fuel Tank Air Filter - Evaporative Emission Control System - Emission Control System - Kia Rio UB 2012-2025 Service ManualKia Rio: Fuel Tank Air Filter

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Lift the vehicle.
3.
Disconnect the canister close valve connector (A).
4.
Disconnect the ventilation hose (B) from the fuel tank air filter and canister close valve.


5.
Remove the fuel tank air filter assembly after removing a bolt (A).


6.
Remove the bracket (A) after pulling it.


7.
Release the lever (A), and then separate the canister close valve (B) from the fuel tank air filter (C) after rotating it in the direction of the arrow in the figure.



Installation

1.
Install in the reverse order of removal.
Fuel Filler Cap
Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler. After the gasket on the fuel filler cap an ...

Exhaust Emission Control System
...

See also:

Fuel Tank Removal
1. Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line"). ...

Front Wheel Speed Sensor Inspection
1. Measure the output voltage between the terminal of the wheel speed sensor and the body ground.    ...

Foot Actuator (With Auto Defogging System) Description
The foot actuator is located at the heater unit. It adjusts position of the foot door in heater unit of the vehicle equipped with the auto defogging system. ...

Copyright www.kirmanual.com 2014-2025