Kia Rio: Description

Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual sensor power and ground line. The second sensor monitors the first sensor and its output voltage is half of the first one. If the ratio of the sensor 1 and 2 is out of the range (approximately 1/2), the diagnostic system judges that it is abnormal.

Accelerator Position Sensor (APS)

...

Specification

Accelerator Position Output Voltage (V) APS1 APS2 C.T 0.7 ~ 0.8 0.275 ~ 0.475 W.O.T 3.8 ~ 4.4 1.75 ~ 2.35 ...

See also:

Ignition Coil: Removal
1. Disconnect the battery nagative terminal. 2. Remove the engine cover. 3. Disconnect the ignition coil connec ...

Ignition Switch Assembly Installation
1. Install the key lock cylinder.    When assembling, the key must be insert ...

Component Location
1. Sunroof 2. Sunroof switch 3. Sunroof motor & controller ...