Kia Rio: Removal - Purge Control Solenoid Valve (PCSV) - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2025 Service ManualKia Rio: Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the purge control solenoid valve connector (A).
3.
Disconnect the vapor hoses (B) from the purge control solenoid valve.
4.
Remove the valve after removing the bolt (C).


Inspection
1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV termi ...

Installation
   • Install the component with the specified torques. • ...

See also:

Starter: Removal and Installation
1. Disconnect the battery negative terminal. 2. Remove the air duct and air cleaner assembly. (Refer to EM group) 3. ...

Components Operations
ECM (Engine Control Module) 1. The ECM(PCM) (A) carries out a check of the ignition key using a special encryption algorithm, which is programmed into the transponder ...

Fuel requirements
Your new Kia vehicle is designed to use only unleaded fuel having a pump octane number ((R+M)/2) of 87 (Research Octane Number 91) or higher. Your new vehicle is designed to obtain maximum performa ...

Copyright www.kirmanual.com 2014-2025