Kia Rio: Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
| •
|
Use care to keep foreign material out of the valve.
|
|
|
1. |
Installation is reverse of removal.
Purge control solenoid valve
bracket installation bolt: 9.8 ~ 11.8 N.m (1.0
~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the purge control solenoid valve connector (A) ...
See also:
Inhibitor Switch Removal
1.
Place the shift lever into the "N" position.
2.
Remove the air cleaner assembly.
(1)
Remove t ...
TPMS Sensor Replacement
Repair tire after using the Tire Mobility
Kit (TMK)
When the TPMS warning lamp OFF
1.
Remove the TMK repaired tire, wheel and TPMS sensor.
(Refer to ...
Front Stabilizer Bar Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the front stabilizer bar for deformation.
3.
Check th ...
Removal
