Kia Rio: Inspection - Fuel Pressure Control Valve - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Inspection

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the fuel pressure regulator valve connector.
3.
Measure resistance between the fuel pressure regulator valve terminals 1 and 2.
4.
Check that the resistance is within the specification.

Specification: Refer to “Specification”

Circuit Diagram
(M/T) (A/T) ...

Canister Close Valve (CCV)
...

See also:

Rear Wiper Motor Installation
1. Install the rubber packing. 2. Install the rear wiper motor assembly. Tightening torque : 6.86 ~ 9.81N ...

Input Speed Sensor Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

Fuel Tank Air Filter
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Lift the vehicle. 3. ...

Copyright www.kirmanual.com 2014-2026