Kia Rio: Installation

Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Lift the vehicle. 3. D ...

ISG (Idle Stop & Go) System

...

See also:

Mode Control Actuator Description
The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch ...

Front Driveshaft Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) fro ...

Hazard Lamp Switch Inspection
1. Operate the switch and check for continuity between terminals. ...