Kia Rio: Defroster - Wipers & Washers - Features of your vehicle - Kia Rio UB 2012-2026 Owners ManualKia Rio: Defroster

CAUTION - Conductors

To prevent damage to the conductors bonded to the inside surface of the rear window, never use sharp instruments or window cleaners containing abrasives to clean the window.

If you want to defrost and defog the front windshield, refer to “Windshield Defrosting and Defogging” in this section.

Rear window defroster


Rear window defroster

The defroster heats the window to remove frost, fog and thin ice from the interior and exterior of the rear window, while the engine is running.

To activate the rear window defroster, press the rear window defroster button located in the center facia switch panel. The indicator on the rear window defroster button illuminates when the defroster is ON.

If there is heavy accumulation of snow on the rear window, brush it off before operating the rear defroster.

The rear window defroster automatically turns off after approximately 20 minutes or when the ignition switch is turned off. To turn off the defroster manually, press the rear window defroster button again.

Outside mirror defroster (if equipped)

If your vehicle is equipped with the outside rearview mirror defrosters, they will operate at the same time you turn on the rear window defroster.

Interior light
Do not use the interior lights for extended periods when the engine is not running. It may cause battery discharge. WARNING - Interior light Do not use the interior lights when driving in the dark. ...

Manual climate control system
1. Fan speed control knob 2. Mode selection knob 3. Temperature control knob 4. Air conditioning button (if equipped) 5. Rear window defroster button 6. Air intake control button Heating and a ...

See also:

Schematic Diagrams
Circuit Diagram (1) Circuit Diagram (2) Circuit Diagram (3) SRSCM Connector Terminal Pin Function (Connector A) Pin Function (Connector B) ...

Oil Pan: Installation
1. Install the oil pan. (1) Using a razor blade and gasket scraper, remove all the old packing material from the gasket surfaces. ...

Inspection
Clutch Pedal Inspection 1. Measure the clutch pedal height (from the face of the pedal pad to the floorboard) and the clutch pedal clevis pin play (measured at the ...

Copyright www.kirmanual.com 2014-2026