Kia Rio: Special Service Tools
| Tool (Number and Name) |
Illustration |
Use |
| 09200-3N000 Engine support fixture (Beam) |
|
Removal and installation of the transaxle. Use this adapter (SST No. : 09200-1P100, 4X000) with the supporter (SST No. : 09200-2S200). ※Permit operating with 09200-38001. |
| 09200-1P100 Engine support fixture (Adapter) |
|
Removal and installation of the transaxle. Use this beam (SST No. : 09200-38001/09200-3N000) with the supporter (SST No. : 09200-2S200) and adapter (SST No. : 09200-4X000) |
| 09200-4X000 Engine support fixture (Adapter) |
|
Removal and installation of the transaxle. Use this beam (SST No. : 09200-38001/3N000) with the supporter (SST No. : 09200-2S200) and adapter (SST No. : 09200-1P100) |
| 09200-2S200 Engine support fixture (Supporter) |
|
Removal and installation of the transaxle. Use this beam (SST No. : 09200-38001/09200-3N000) with the adapter (SST No. : 09200-1P100, 4X000) |
| 09452-26100 Oil seal installer |
|
Installation of transaxle case oil seal. [Using with handle (SST No.:09231-H1100)] |
| 09231-H1100 Bar |
|
Installation of transaxle case oil seal. [Using with oil seal installer (SST No.:09452-26100)] |
| 09480-A3800 Inhibitor switch guide pin |
|
※ Engine support fixture special tool assembly drawing
| 1. 09200-3N000(Main bar) 2. 09200-3N000(Sub bar) 3. 09200-3N000(Handle) 4. 09200-3N000(Stopper) 5. 09200-3N000(Bolt-1) 6. 09200-4X000 (Adapter) 7. 09200-1P100(Supporter) 8. 09200-2S200(Supporter) 9. 09200-3N000(Nut) |
10. 09200-3N000(Snap ring) 11. 09200-3N000(Sub fixture) 12. 09200-3N000(Stopper) 13. 09200-3N000(Nut) 14. 09200-2S100(Spacer) 15. 09200-1P100(Sub fixture) 16. 09200-1P100(Nut) 17. 09200-3N000(Pin) |
Lubricants
Item
Specified lubricant
Quantity
Transaxle fluid
ATF SP-Ⅳ or equivalent
7.3L (1.93 U.S gal., 7.71 U.S.qt., 6.42 Imp.q ...
See also:
TPMS Sensor Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents
are as follows:
1.
Connect self-diagnosis connector(16pins) located in the lower
of driv ...
Side Airbag (SAB) Module Removal
The side airbag cannot be disassembled from the seat back assembly,
so replace the seat back assembly when replacing the ...
Heated Steering wheel Inpection
1.
Measure a resistance of NTC and Heated pad.
A.
NTC resistance(Black / Yellow, Black) - 10.0 kΩ ± 10%
(25°C(77°F))
...
Copyright © www.kirmanual.com 2014-2024