Kia Rio: Underdrive Brake Control Solenoid Valve(UD/B_VFS) Inspection

1.	Turn ignition switch OFF.

2.	Disconnect the solenoid valve connector.

3.	Measure resistance between sensor signal terminal and sensor ground terminal.

4.	Check that the resistance is within the specification.

Underdrive Brake Control Solenoid Valve(UD/B_VFS) Circuit Diagram

...

Underdrive Brake Control Solenoid Valve(UD/B_VFS) Removal

Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

See also:

Front Driveshaft Component
1. Driveshaft (LH) 2. Circlip 3. Circlip 4. Driveshaft (RH) ...

Flat tire
Jack and tools The spare tire, jack, jack handle and wheel lug nut wrench are stored in the luggage compartment. Remove the luggage under tray out of the way to reach the equipment. (1) Jack ha ...

Blower Resistor (MANUAL) Replacement
1. Disconnect the negative (-) battery terminal. 2. Disconnect the connector (A) and then remove the blower resistor (B) after loosening th ...

Categories

Copyright © www.kirmanual.com 2014-2026