Kia Rio: Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to "Valve Body" in this group)
|
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor ...
SS-A Solenoid Valve(ON/OFF) Description
SS-A solenoid valve is attached to the valve body and is an on/off solenoid
valve that is used to change gears. SS-A Solenoid valve(ON/OFF) is installed
at valve body.
...
See also:
Road warning
Hazard warning flasher
The hazard warning flasher serves as a warning to other drivers to exercise extreme
caution when approaching, overtaking, or passing your vehicle.
It should be used whenev ...
Removal
1.
Remove the under cover.
2.
Remove the mounting nut and disconnect the horn connector, then
remove the horn (A).
...
Foot Actuator (With Auto Defogging System) Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the foot connector.
3.
Verify that the foot actuator operates to ...
Copyright © www.kirmanual.com 2014-2024