Kia Rio: Front Hub / Knuckle Inspection

Front Hub / Knuckle Reassembly

1. Install the hub bearing to the knuckle assembly. (1) Lay the knuckle assembly (A) on press. (2) ...

Driveshaft Assembly

...

See also:

ECM Problem Inspection Procedure
1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...

Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The top waveform is from the high side (feed side) of the #1 and #4 injectors, while the middle waveform is from the low side ...

Removal
1. Remove the under cover. 2. Remove the mounting nut and disconnect the horn connector, then remove the horn (A). ...