Kia Rio: Installation| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable and wait for at least thirty
seconds.
|
| 3. |
Install the seat belt pretensioner with bolts (B, C).
|
| 4. |
Connect the seat belt pretensioner connector (A).
|
| 5. |
Install the upper anchor bolt.
|
| 6. |
Install the center pillar trim.
(Refer to the Body group - "Interior trim")
|
| 7. |
Install the door scuff trim.
(Refer to the Body group - "Interior trim")
|
| 8. |
Insert the seat belt to the anchor pretensioner.
|
| 9. |
Reconnect the battery negative cable.
|
| 10. |
After installing the seat belt pretensioner, confirm proper system
operation:
|
Removal
Anchor Pretensioner (APT) DescriptionValve Body Components Location
1. PCV adjust screw
2. Solenoid valve
3. Oil temperature sensor
4. Accumulator
5. Low & reverse brake(LR/B) pressure flow hole
6. Under drive brake (UD/B) pressur ...
Engine Oil: Oil And Filter Replacement
•
Prolonged and repeated contact with mineral oil will result
in the removal of natura ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the rear seat (Refer to "Seat" in BD gro ...