Kia Rio: Installation

1.

Installation is the reverse of removal.

A.	Before installing the pin, apply the grease to the joint pin.

B.	Use a new snap pin whenever installing.

2.	After installing, bleed the brake system. (Refer to Brake system bleeding)

3.	Adjust the brake pedal height and free play. (Refer to Brake pedal height and free play adjustment)

Inspection

1. Inspect the check valve in the vacuum hose. Do not remove the check va ...

Master Cylinder

...

See also:

Mode Control Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode con ...

Rear Wiper Motor Installation
1. Install the rubber packing. 2. Install the rear wiper motor assembly. Tightening torque : 6.86 ~ 9.81N ...

Description
The charging system included a battery, an alternator with a built-in regulator, and the charging indicator light and wire. The Alternator has eight built-in diodes, each rectifying AC curre ...

Categories

Copyright © www.kirmanual.com 2014-2026