Kia Rio: 4Door Interior


Front pillar trim mounting hole (Ø8.5)	Curtain airbag mounting hole (Ø6.6)	Cowl crossbar mounting hole (Ø6.6)

Front pillar inner panel tooling hole (7X12)	Front door checker mounting hole (Ø11)	Seat belt height adjuster mounting hole (Ø16)

Seat belt height adjuster mounting hole (Ø16)	Seat belt retractor mounting hole (Ø12)	Rear door checker mounting hole (Ø11)

Curtain airbag mounting hole (Ø6.6)	Curtain airbag mounting hole (Ø6.6)	Quarter inner lower panel tooling hole (Ø8.5)


Quarter inner lower panel tooling hole (Ø10)	Rear door striker mounting hole (Ø13)

4Door Side Body

Front side member tooling hole (Ø12) Fender apron upper member tooling hole (Ø7) Front door upper hinge ...

4Door Rear Body

Side outer panel rear corner Side outer panel rear corner Side outer panel rear corner ...

See also:

Failure Diagnosis
1. In principle, ESC and TCS controls are prohibited in case of ABS failure. 2. When ESC or TCS fails, only the failed system control is pr ...

Input Speed Sensor Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

Muffler: Removal and Installation
1. Disconnect the battery negative terminal. Tightening torque Without battery sensor : 7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ ...

Categories

Copyright © www.kirmanual.com 2014-2025