Kia Rio: Seat Heater Inspection

Driver seat and Passenger seat

1.

Check for continuity and measure the resistance between terminals.

[Cushion]

Pin No.	Description	Pin No.	Description
1	Heater(-)	4	NTC -
2	Heater(+)	5	NTC +

Average Max. temperature

- Cushion : HIGH : 42 Â± 2Â°C / LOW : 39 Â± 2Â°C

- Back : HIGH : 52 Â± 2Â°C / LOW : 46 Â± 2Â°C

2.

Operate the seat heater after connecting the connector, and then check the thermostat by measuring the temperature of seat surface.

Standard value (Fabric / Leather)

- Cushion : 1.18Ω Â± 10%

- Back : 1.13Ω Â± 10%

- Set : 2.31Ω Â± 10%

Seat Heater Components

...

Seat Heater Switch Schematic Diagram

...

See also:

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line (Refer to the ...

Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine ...

Inhibitor Switch Description
Inhibitor Switch monitors the lever's position(PRND) and is used to control gear setting signals. ...

Categories

Copyright © www.kirmanual.com 2014-2026