Kia Rio Manuals

Kia Rio: Side Impact Sensor (SIS) Removal - SRSCM - Restraint - Kia Rio UB 2012-2026 Service ManualKia Rio: Side Impact Sensor (SIS) Removal

Pressure Side Impact Sensor

     
•
Removal of the airbag must be performed according to the precautions/procedures described previously.
•
Before disconnecting the side impact sensor connector(s), disconnect the side airbag connector(s).
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front door trim.
(Refer to the Body group - "Front door")
3.
Disconnect the pressure side impact sensor connector (A) and remove the pressure side impact sensor mounting screws (B).
Side Impact Sensor
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the door scuff trim.
(Refer to the Body group - "Interior trim")
3.
Remove the center pillar trim.
(Refer to the Body group - "Interior trim")
4.
Disconnect the side impact sensor connector (A).
5.
Loosen the side impact sensor mounting bolt and remove the side impact sensor (B).
Side Impact Sensor (SIS) Components
...

Side Impact Sensor (SIS) Installation
Pressure Side Impact Sensor 1. Install the new pressure side impact sensor with the screws (B) then connect the pressure side impact sensor connector (A). ...

See also:

ESC OFF Switch Description
1. The ESC OFF switch is for the user to turn off the ESC system. 2. The ESC OFF lamp is on when ESC OFF switch is engaged. ...

Front Washer Motor Inspection
Front Washer Motor 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. &nb ...

Inspection
Clutch Pedal Inspection 1. Measure the clutch pedal height (from the face of the pedal pad to the floorboard) and the clutch pedal clevis pin play (measured at the ...

Categories

Copyright www.kirmanual.com 2014-2026